Configures router interfaces for Routing and Remote Access Service.
Adds an interface to the router, specifying its name
iname) and type
tunnel for VPN interfaces and
full for demand-dial interfaces). The name of the
interface must be in quotes if it contains spaces.
Removes the specified interface.
Dumps the configuration of the interfaces for the Routing and Remote Access Service as a series of NetShell commands.
Switches to the IP subcontext to further configure IP interfaces on the router. The commands available in this subcontext are listed in Table 5-11.
Resets the router configuration by deleting all interfaces.
Specifies the credentials needed to connect to an interface.
Sets the current state of the WAN interface called
iname to either
specified, the interface is automatically enabled.
newiname is used only for renaming the default LAN
Displays the credentials needed to connect to each interface.
Displays the name, type, and current state of each interface on the router. If no name is specified, all interfaces are displayed.
Table 5-11. Commands available ...