O'Reilly logo

VoIP Voice and Fax Signal Processing by Sivannarayana Nagireddi

Stay ahead with the world's most comprehensive technology and business learning platform.

With Safari, you learn the way you learn best. Get unlimited access to videos, live online training, learning paths, books, tutorials, and more.

Start Free Trial

No credit card required

11.3 ETHERNET, DSL, AND CABLE INTERFACES FOR VoIP

In this chapter, Ethernet, DSL, and cable interface options are considered for VoIP bit rate calculations. Figure 11.2(a) shows the VoIP adapter or customer premises equipment (CPE) with an Ethernet interface. This type of combination is referred to as a VoIP CPE on a local area network (LAN) interface. This Ethernet interface is terminated on the distributed LAN in an office or to a service provider's modem such as DSL or cable modem. VoIP CPE will send Ethernet packets, and the DSL modem will perform disassembly of the Ethernet packet and frames into asynchronous transfer mode (ATM) cells (as one of the options considered in this book) for sending on the DSL interface. In Fig. 11.2(b), VoIP CPE has a built-in DSL modem. The VoIP application gives a basic payload, and the DSL interface will send voice packets as ATM cells usually with PPPoE. In some deployments, PPP over ATM (PPPoA) [Gross et al. (1998), Heinanen (1993)] and IP over ATM (IPoA) [Laubach and Halpern (1998)] may be used. PPPoA and IPoA consume a lower bit rate than PPPoE. In this chapter, four different interface combinations are considered for bit rate calculations with G.711, G.729A, and G.723.1 codecs.

image

Figure 11.2. VoIP on physical interfaces. (a) VoIP on an Ethernet interface. (b) VoIP on a DSL interface. (c) VoIP on a cable interface.

  1. VoIP voice packets on an ...

With Safari, you learn the way you learn best. Get unlimited access to videos, live online training, learning paths, books, interactive tutorials, and more.

Start Free Trial

No credit card required