You are previewing Snip, Burn, Solder, Shred.

Snip, Burn, Solder, Shred

Cover of Snip, Burn, Solder, Shred by David Erik Nelson Published by No Starch Press
O'Reilly logo

Building It

  1. Start with the pitch controller (shown in Figure 17-4), since that will need to dry overnight. Take a 5″ length of coat hanger (or similar stiff wire), and curl one end so that it hooks snugly around the end of your cylindrical control knob. Cut a 1″ circle of playing card; this will serve as a stylish knob cover. Put a penny-sized dollop of Gorilla Glue in the center of the playing-card circle. Press the top of the knob into the glue (forcing some out around its edges), and then hook the wire around it. Apply a little more glue to cover the wire (if needed), clean up any excess, and let this dry overnight. Remember that Gorilla Glue foams as it cures; an innocuous little smear can dry into a big foamy mess.

    Figure 17-4. Building the ...

The best content for your career. Discover unlimited learning on demand for around $1/day.