Running into Trouble
Often, something will not be
quite right when you initially fire up the X server. This is almost
always caused by a problem in your XF86Config
file. Usually, the monitor timing values are off or the video card
dot clocks are set incorrectly. If your display seems to roll, or the
edges are fuzzy, this is a clear indication that the monitor timing
values or dot clocks are wrong. Also be sure you are correctly
specifying your video card chipset, as well as other options for the
Device
section of XF86Config
.
As of XFree86 Version 4, there is only one server binary, which loads
the module needed for the graphics card in question. The module that
loads depends on your Device
settings.
If all else fails, try to start X “bare”; that is, use a command, such as:
X > /tmp/x.out 2>&1
You can then kill the X server (using the Ctrl-Alt-Backspace key
combination) and examine the contents of
/tmp/x.out
. The X server reports any warnings or
errors — for example, if your video card doesn’t
have a dot clock corresponding to a mode supported by your monitor.
This output can be very helpful in diagnosing all kinds of problems.
Examine it closely if your X server does not start up at all, does
not provide the resolutions you wanted, or shows a flaky, snowy, or
otherwise insufficient picture. Even if everything works to your
satisfaction, you might want to check this file for interesting
information that the X server has found out about your hardware. The
lines starting with (**) ...
Get Running Linux, Fourth Edition now with the O’Reilly learning platform.
O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.