O'Reilly logo

Power Over Ethernet Interoperability Guide by Sanjaya Maniktala

Stay ahead with the world's most comprehensive technology and business learning platform.

With Safari, you learn the way you learn best. Get unlimited access to videos, live online training, learning paths, books, tutorials, and more.

Start Free Trial

No credit card required

Detection Signature Resistor Disengagement Concerns
At this point it is a good idea to recall/repeat the discussion in the previous chapter on a very basic issue: the presence of the 25-k detection resistor. In almost all cases discussed so far, and also in related literature, this resistor is shown as a stand-alone component just past the bridge on the PD-chip-side. It is “always present.” So when the voltage ramps up into the classification range (~18 V), it continues to draw current, of about 18/25 k = 0.7 mA. Not a big deal, and though it adds some current to the constant class-current-sink, its effect is less than 1 mA. When the port is fully powered up, it continues to draw about 50 V/25 k = 2 mA. In terms of wattage this is 50 V × 2 mA ...

With Safari, you learn the way you learn best. Get unlimited access to videos, live online training, learning paths, books, interactive tutorials, and more.

Start Free Trial

No credit card required