Time for action – configuring fast-start failover
The following steps will help you configure FSFO in a configuration managed by the Data Guard broker:
- Check if Data Guard is in the Maximum Performance(11gRx) or Maximum Availability mode using the following command:
DGMGRL> show configuration
Configuration - PACKT
Protection Mode: MaxPerformance
TURKEY_UN - Primary database
INDIA_UN - Physical standby database
Fast-Start Failover: DISABLED
- If your configuration is in the Maximum Availability mode, make sure that
LogXptMode is set to synchronous redo transport.
- Make sure you have configured a flashback database and fast recovery area. This is applicable on both the primary and standby databases and helpful ...