DHCP configuration at the console can be done with the following steps:
- At the console, select Set interface(s) IP address on the menu.
- Select the interface on which you want to run the pfSense DHCP server (this is usually a LAN, but it could be any interface other than the WAN interface). You will be prompted for the interface's IPv4 IP address.
- Type in the address (or leave the line blank for none) and press Enter.
- The next prompt is for the subnet bit count. Type in the correct bit count and press Enter.
- Next, you will be prompted for the upstream gateway address. You do not need to provide this information, so just press Enter. IPv4 address configuration is now complete.
- The next prompt will be for the ...