Command |
Response |
Parameters |
Description |
AT+UART?
|
+UART:<Param1>, <Param2>, <Param3>
|
Param1 = Baud Rate Param2 = Stop Bit Param3 = Parity |
Queries the UART parameters.
|
Command |
Response |
Parameters |
Description |
AT+UART=<Param1>, <Param2>, <Param3>
|
OK
|
Param1 = Baud Rate Param2 = Stop Bit Param3 = Parity |
Sets the UART parameters. |