The Internet Engineering Task Force(IETF) is responsible for defining the standard protocols that govern Internet traffic, including SNMP. The IETF publishes Requests for Comments(RFCs), which are specifications for many protocols that exist in the IP realm. Documents enter the standards track first as proposed standards, then move to draft status. When a final draft is eventually approved, the RFC is given standard status -- although there are fewer completely approved standards than you might think. Two other standards-track designations, historical and experimental, define (respectively) a document that has been replaced by a newer RFC and a document that is not yet ready to become a standard. The following list includes all the current SNMP versions and the IETF status of each (see Appendix D for a full list of the SNMP RFCs):
SNMP Version 1 (SNMPv1) is the current standard version of the SNMP protocol. It’s defined in RFC 1157 and is a full IETF standard. SNMPv1’s security is based on communities, which are nothing more than passwords: plain-text strings that allow any SNMP-based application that knows the strings to gain access to a device’s management information. There are typically three communities in SNMPv1: read-only, read-write, and trap.
SNMP Version 2 (SNMPv2) is often referred to as community string-based SNMPv2. This version of SNMP is technically called SNMPv2c, but we will refer to it throughout this book simply as SNMPv2. It’s defined in RFC 1905, RFC 1906, and RFC 1907, and is an experimental IETF. Even though it’s experimental, some vendors have started supporting it in practice.
SNMP Version 3 (SNMPv3) will be the next version of the protocol to reach full IETF status. It’s currently a proposed standard, defined in RFC 1905, RFC 1906, RFC 1907, RFC 2571, RFC 2572, RFC 2573, RFC 2574, and RFC 2575. It adds support for strong authentication and private communication between managed entities. Appendix F provides an introduction to SNMPv3 and goes through the SNMPv3 agent configuration for Net-SNMP and Cisco. The information in this appendix provides any system or network administrator with the practical knowledge needed to begin using SNMPv3 as it gains acceptance in the network-management world.
The official site for RFCs is http://www.ietf.org/rfc.html. One of the biggest problems with RFCs, however, is finding the one you want. It is a little easier to navigate the RFC index at Ohio State University (http://www.cis.ohio-state.edu/services/rfc/index.html ).
Get Essential SNMP now with the O’Reilly learning platform.
O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.
