I am going to use some basic routers for these labs, but really, almost any Cisco router will work.
Here is a list of the labs in this chapter:
Lab 13.1: Preparing for NAT
Lab 13.2: Configuring Dynamic NAT
Lab 13.3: Configuring PAT
I am going to use the network shown in the following diagram for our hands-on labs. I highly recommend you connect up some routers and run through these labs. You will configure NAT on router Lab_A to translate the private IP address of 192.168.10.0 to a public address of 184.108.40.206.
Table 13-3 shows the commands we will use and the purpose of each command.