Section 1.0: Basic Configuration

1.1. IP Addressing

  1. Configure IP addresses as per the topology diagram shown in Figure 1-1.

  2. Configure all the loopbacks and advertise them as per the instructions in different sections of the exercise.

  3. Configure a default route on R2 to Ethernet 0/0. This will show “Gateway of last resort is 0.0.0.0” in your routing table. Propagate the default route to all other routers.

  4. Configure default-information originate always on R2. Do not configure any static routes unless otherwise specified.

1.2. Frame Relay Configuration

  1. Map only DLCIs specified in the diagram. Do show frame-relay map and check to see if there are any additional DLCIs dynamically populated that are not required. If so, turn off inverse-arp on that interface ...

Get CCIE Security Practice Labs now with the O’Reilly learning platform.

O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.

Start your free trial