Section 6: DLSw (4 Points)
Configure DLSw between VLAN_11 and VLAN_33. Use FST encapsulation.
If you configured this correctly as shown in Example 5-37, you have scored 2 points.
Example 5-37 has the DLSw configuration between R1 and R3 using FST encapsulation. Example 5-37 shows how to set up the peers and how to verify if the DLSw configuration up and running. Notice the state “CONNECT,” which means the DLSw tunnel is up, running, and connected. If the state shows something different, you need to doublecheck your configurations and make sure your IGP is also running fine.
Because it is a “bridge” environment, you need to have the Spanning Tree Protocol enabled. You enable Spanning Tree Protocol using the bridge protocol command.
Example 5-37. ...
Get CCIE Routing and Switching Practice Labs now with the O’Reilly learning platform.
O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.
