Section 8: Multicast (6 Points)
Configure Multicast PIM Sparse-mode on VLAN_22 to allow Multicast traffic between R3, R5, and R6. Make R6 the rendezvous point.
If you configured this correctly as shown in Example 4-43, you have scored 3 points.
To better control the interval of PIM query messages, change the frequency of sending these messages to 1 minute.
If you configured this correctly as shown in Example 4-43, you have scored 3 points.
Example 4-43 shows the multicast configuration according to the question requirement regarding the PIM mode and the rendezvous point. The show commands tell you if the RP is found and if the neighborhood is made.
Example 4-43. R3, R5, and R6 Multicast Configuration
R3#show run Building configuration... ! ! ... |
Get CCIE Routing and Switching Practice Labs now with the O’Reilly learning platform.
O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.
