Section 8: QoS (5 Points)
Configure a QoS policy on R2 for traffic flowing from VLAN1 toward the rest of your network. Traffic found to have an IP precedence of 7, 5, and 1 should be limited to a maximum of 2 Mbps. Traffic above this figure with the stated precedence should be discarded. Use only one ACL to accomplish this requirement. Assume normal and excess burst sizes to both be 40000.
A future FXS module will be installed into R6 and VoIP traffic will flow between R1 and R6. Configure RSVP on R1 so that the RSVP setup must be complete before the destination phone rings. Each RSVP flow should be set to 100 kbps and allow for a maximum of 2 flows; allow a maximum of 15 seconds for this setup. You should also allow for 64 discard messages and ...
Get CCIE Routing and Switching Practice Labs now with the O’Reilly learning platform.
O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.
