Analog Electronics with LabVIEW®

PA.3. Plotting Measured Samples

Open PlotSamples.vi. Prepare the Diagram for displaying the samples. For high resolution (discussed later), set the high limit and low limit as shown in the example to 1 V and 0 V, respectively. The number of samples can be 10 to 100 and is not critical at this point. We only want to gain some experience with graphs and display the point scatter expected under the conditions set up here. The number of samples is 40 in the example. Go to the Front Panel to run the VI with the voltage sent out similar to that shown in the example, 0.1 V. This must be lower than the high limit setting for the DAQ input, which is ...